Longfield CV and Axle Kit (30 Spline) Suitable For Toyota LandCruiser 80 Series (Each) - 301720-1-KIT

Brand: Trail Gear	Product ID: 31807
	SKU: 301720-1-KIT
Low Stock (This item could be out of stock. If it is, we will contact you after your order is placed. Alternately, please contact us to check current stock levels.)

RRP:  $1,753.00
Special Price:  $1,402.00  (Each)
SAVE:  $351.00

Supply Only Price.

qty :

***Currently In Stock***

Longfield™ FJ80 Gun Drilled 30-Spline Super Set

The Longfield™ FJ80 Gun Drilled 30-Spline Birfields are made out of 100% Chromoly and are precision polished to remove any imperfections that may cause stress risers. The internals of the birfield are also made from 4340 Chromoly and are dual heat treated for superior strength. The birfield has an M8 grease zerk at the end of the stub shaft and is gun drilled through the centre of the birfield to allow for grease to pass through the zerk fitting and into the internals. This will save you precious time by eliminating the need to disassemble your axle just to service your birfields.
The FJ80 Gun Drilled 30-Spline Birfields also have a shallow relief near the splines on the stub shaft known as a Machined Spline Saver. The Machined Spline Saver eliminates stress concentrations caused by grooving from the tool that makes the splines on the stub shaft. The stress concentration from the spline groove is a common failure point on birfield stub shafts. The stub shaft of the Birfield has dual snap ring grooves to accommodate FJ80s with short and long drive flanges.
The axle shafts are also made out of 4340 Chromoly steel.
Included in this kit is a set of new FJ80 ABS Tone Rings. This will allow you to install the Longfield™ FJ80 Gun Drilled 30-Spline Super Set on both ABS and Non-ABS FJ80 applications. No other kit on the market can compare.
Note: Included is the FJ80 Extended Dust Caps for 1990-1993 models that use short drive flanges.

Genuine/Non Genuine – Advertised parts are not genuine (unless specifically stated) and manufacturer references are for application purposes only. Only items that are specifically noted as Genuine OEM can be presumed as genuine parts.

Superior Engineering is not sponsored, approved, affiliated or otherwise associated with any genuine or original parts manufacturer, distributor or dealer.

Identification and Guidance Only – Photos are for identification purposes only and may be of either genuine or non-genuine parts.
All manufacturers names, symbols and descriptions on this website are used for reference purposes only, and it is not implied that any units or parts listed is the product of these manufacturers.

Original Equipment Manufacturer "OEM" part/reference numbers are listed for information/reference purposes only. Trademarks identifying these parts are those of each OEM and are the property of their owners and are not used, or authorized for use, by Superior Engineering. Cross-referenced parts from the Original Equipment Manufacturer "OEM" are listed for information purposes only.

Superior Engineering has no associations and/or claims to be associated with OEM Vehicle Manufacturers and their Companies worldwide. Any implied associations are purely coincidental and are not inferred. Superior Engineering is a supplier of fully interchangeable non-genuine spare parts (alternatives) for equipment produced by manufacturers using in accordance with law OEM Vehicle Manufacturers and their products, i.e. suspension parts, steering components, manufactured items, vehicle accessories etc. Alternative spare parts produced by Superior Engineering are manufactured according own technological documentation developed with the use of reverse engineering.